Why use a retroreflectometer for traffic signs?

Retroreflectometer for traffic signs is mainly used for the detection of traffic signs. Many people may have doubts about why traffic signs still need to be detected? I have had this before, but then after a detailed understanding of the use of the detection is very significant. Our current single-angle model is TBTTSR-1J and the multi-angle model is TBTTSR-1M. The next is the introduction of the reasons for use and attention.

Reasons for use

Our knowledge of many traffic signs is that we can drive according to the content of the signs in the process of driving, for example, there are requirements for speed on some roads, and there are some signs for general direction on some highways, and these are the roles played by traffic signs. So, we can drive according to the content of the signs when driving the vehicle so that we can also be in a stable state when driving. We know traffic signs in our usual driving vehicles are very important. But because traffic signs are on the side of the road, after a long time of use may appear faded and rusty, and even that some of them are accessible to people, then there may be people above the smear, which is also very affected by our view and may even fall directly to fall off. So, this time to use the retroreflectometer for traffic signs to measure, so that you can timely find the damage of the traffic signs and timely adjustment.

In recent years the new driverless technology is also a lot of attention, and driverless cars also need to be based on traffic signs to determine how to drive on the road.

Attention

Generally, when the weather conditions are good, you can use the retroreflectometer for traffic signs. In rainy or humid weather, you need to pay extra attention to the use, especially to be careful of splashing rainwater, but generally, rainwater is not directly into the interior of the dashboard. Therefore, it is only necessary to clean the outside of the retroreflectometer for traffic signs with a damp cloth. There is no need to use cleaning agents, etc.when cleaning. If there is dust on the calibration base, you can choose to remove it by compressed air or, more simply, by using a soft, damp cloth.